Glovebox dewpoint meter design EA2-TX-100 is easy to use, it integrates characteristics are as far as possible to simplify the installation and use of services. This is completely set up and calibrated so that the dew point transmitter for the first time become as easy to measure temperature and pressure measurements, can access directly to your air or gas management and control systems. Dewpoint meter glovebox highlights? Two-wire loop power supply connection? Dew point units or ppm moisture content per unit? IP66 (NEMA 4)? Excellent sensor protection? Range -100 ~ +20 ° C? Operating temperature -40 ~ 60 ° C ? fast response glovebox Dewpoint Dewpoint Meter Specifications Performance range -100 ~ +20 ° C dew dew dew point accuracy of ± 2 ° C T95 response time of 5 minutes (from dry to wet) Repeatability 0.5 ° C dew point Input / Output Signal 4-20 mA (two-wire) active output, full range can be customized dew point -100 ~ + 20 ° C -148 ~ +68 ° F 0-3000 ppmV ppmV output or output range of non-standard must specify when the next one Supply voltage 12-28 V DC resistive load maximum 250 Ω @ 12 V 500 Ω @ 24 V Current consumption 20mA max power fluctuations ± 0.005% RH / V working conditions Operating temperature -40 ~ +60 ° C Operating Humidity 0-100 % RH maximum working pressure of 45 MPa (450 barg) Flow 1 ~ 5 Nl / min, installed in a standard sampling sleeve; 0 to 10m/sec, temperature compensation and mechanical properties have been sealed protective plug directly within the operating temperature range temperature coefficient corresponding to IP66 standard BS EN 60529:1992, as well as the corresponding standard NEMA 4 housing material stainless steel NEMA 250-2003 Size L = 132mm x 27mm Mounting Thread 5/8 "-? 18 UNF Weight 150g HDPE protective cap 80μm filter Stainless steel protective cap (optional) Electrical connections see table interchangeable interchangeable sensor fault profiles (factory setting) 23 mA sensor fault status output dew point below the dew point range 4 mA 20 mA overrange